Whirlpool Washer ADG 6500 ユーザーズマニュアル

GB -5-

6

7

8

Maintenance and care

Overview of programs
The max. possible number of programs is illustrated in the chapter “Chart”. The corresponding programs for your appliance can be found on the panel (page 1).

Choose program according to the attached table of programs (page 1).
Duration of the program depends on the external conditions in the apartment, temperature and pressure etc.

10

9

Filters
Check and 
clean if 
necessary

Unscrew 
microfilter (1), 
remove it (2) 
and remove 
fine sieve (3)...

Rinse under 
running water...

Screw on microfilter NOTE MARK!

Unscrew 
and remove 
lower arm...

Spray arms 
Remove
blockages/
deposits.

Insert

Clean spray 
nozzles under 
running water
(use toothpicks 
if necessary)...

Insert and screw on upper and lower arms tightly.

Unscrew 
and remove 
upper arm...

After the program is completed appliance turns into Standby mode automatically. All indicator lamps switch off.
Exercise caution when opening the door: beware of hot steam. 
Unload the appliance starting from the lower rack in order to avoid any residual drips of water falling onto crockery below. 

The dishwasher door must be closed and the water tap open.

- Open the door with caution (the program pauses) and insert 

the item/s,
(beware of HOT steam!).

- Press  the  START button and close the door within 3 seconds 

(the program resumes the cycle from where it was 
interrupted).

- Open the door, press the CANCEL/

Off button and close the door.

- (Water drains for up to 1 minute then 

the appliance switches off).

To change the program in progress:
- Open the door, press the CANCEL/Off button to cancel the 

running program and close the door.

- (Water drains for up to 1 minute then the appliance switches off).
- Open the door and press any button except CANCEL/Off button to 

switch on the appliance.

- Select a new program.
- Press the START button and close the door within 3 seconds