Whirlpool MEDB850YG インストール手順

Using a 4" (102 mm) clamp, connect vent to exhaust outlet  

in dryer. If connecting to existing vent, make sure vent is 

clean. Dryer vent must fit over dryer exhaust outlet and inside 

exhaust hood. Check that vent is secured to exhaust hood 

with a 4" (102 mm) clamp.

Move dryer to final location. Avoid crushing or kinking vent. 

After dryer is in place, remove cardboard from under dryer.

       Not Level 

            

LEVEL                    Not Level

Check levelness of dryer from side to side. Repeat from  

front to back. 

NOTE: The dryer must be level for the moisture sensing system 

to operate correctly.

Place 

level here

Place 

level here

If dryer is not level, prop up using a wood block, use wrench  

to adjust legs by backing out the foot as needed, then checking 

again for levelness. Once legs are level, make sure all four legs 

are snug against the floor.