Whirlpool MEDB850YG インストール手順

You can change your door swing from a right-side opening to a 

left-side opening, if desired.

1.  Place a towel or soft cloth on top of dryer or work space to 

avoid damaging the surface.

1. Open the dryer door.
2.  Remove the bottom screw (B) from each of the two hinges that 

attach dryer door to front panel of dryer.

3.  Loosen the top screw (A) from each of the two hinges  

in Step 2.

4.  Remove the dryer door and the hinges by lifting upward on the 

door. Lay the door on a flat, covered surface, with the inside of 

the door facing up. Remove remaining two loose screws from 

dryer front panel.

5.  Remove the 4 plastic plugs located outside the dryer door 

opening.

6.  Install 4 plastic plugs into screw holes in the dryer left where 

the hinges were removed in Step 4.

  

 

 

          A. Top screw 

B. Bottom screw

q

  Check that all parts are now installed. If there is an extra  

part, go back through steps to see what was skipped.

q

  Check that you have all of your tools.

q

  Dispose of/recycle all packaging materials.

q

  Check dryer’s final location. Be sure vent is not crushed  

or kinked.

q

  Check that dryer is level. See “Level Dryer.”

q

  Remove film on console and any tape remaining on dryer.

q

  Wipe dryer drum interior thoroughly with a damp cloth to    

remove any dust.

q

  Read “Dryer Use” in your “Use and Care Guide.”

q

  For power supply cord installation, plug into a grounded  

outlet. For direct wire installation, turn on Power.

q

  Be sure the water faucets are on.

q

  Check for leaks around “Y” connector, faucet, and hoses.

q

  If you live in a hard water area, use of a water softener is    

recommended to control the buildup of scale through the    

water system in the dryer. Over time, the buildup of lime  

scale may clog different parts of the water system, which will  

reduce product performance. Excessive scale buildup may  

lead to the need for certain part replacement or repair.

q

  Select a Time Dry heated cycle, and start dryer. Do not select  

 

Air Only Temperature setting.

      If dryer will not start, check the following:

• Controls are set in a running or “On” position.
• Start button has been pushed firmly.
• Dryer is plugged into an outlet and/or electrical supply.
• Household fuse is intact and tight, or circuit breaker has  

  not tripped.
• Dryer door is closed.

This dryer automatically runs an installation diagnostic routine  

at the start of its first cycle.

If you receive an L2 code, there may  be a problem with you 

home power supply keeping the dryer’s heater from turning on. 

See “Troubleshooting.”

If your Airflow screen reads “Check Vent”, your dryer vent may  

be crushed or blocked. See “Troubleshooting.”

You may notice an odor when dryer is first heated. This 

odor is common when heating element is first used. The odor will 

go away.