Precision Trading 60 R3.0 ユーザーズマニュアル

Operator Manual, Supercharger 60 

R3.0 

 

 

9.2.5.2.  VOLTAGE CONTROL - See [Figure 10] 

9.2.5.2.1. 

R11, FLOAT VOLTAGE: 

•  Connect a CAL-100 Calibrator or a power supply 

capable of producing at least 10V (very little current 
required) to the CAL (-) and CAL (COMMON) test 
points. The positive lead to   COMMON and the 
negative lead to CAL (-). 

•  Set the calibrator/power supply to 2.70V to simulate 

a battery that has 27.0V. 

• 

 

•  Connect a battery to the Charger-Analyzer. 
•  Set the Voltage Control Mode Switch to CV 

(Constant Voltage) 

•  Program for 10A of Topping current. 
•  Enter 24 in the cell selector (nominal battery 

voltage). 

•  Start the Charger-Analyzer in Single rate. The 

current will rise to the programmed 10A. 

•  Increase the power supply voltage towards 2.8V and 

observe the current. 

•  The charging current will begin to decrease at about 

2.75V and should reach zero as the voltage is 
advanced to 2.8V. 

•  NOTE:  Ignore the actual battery voltage. The Float 

voltage control circuit is responding to the simulated 
battery voltage as provided by the power supply.