Technicolor - Thomson Electronic Accessory Gecko Frames Signal Processing System ユーザーズマニュアル

There are ten cell locations in each frame to accommodate either video or 
audio modules (module types cannot be mixed in a frame). These are the 
ten cells located on the left side of the frame. Refer to 

Modules can be configured for up to eight outputs. The 8500 modules have 
six outputs. The 8800 and 8900 modules have eight outputs. Refer to indi-
vidual module manuals for input/output configuration information.

The two cells on the right are allocated for the power supplies only. 

The third cell from the right, is allocated only for the Frame Monitor or 
8900NET Network Interface module. This module provides the interface 
for the forced-air cover, as well as the Frame Alarm reporting. For addi-
tional information concerning the Frame Monitor and Network Interface 
modules, refer to 

To install a module into the frame, follow these steps:

Insert the module into the frame, connector-end first, with component 
side of the module facing to the right with the ejector tab at the top. The 
Frame Monitor and the 8900NET module have a connector tab with a 
circular finger-hole for pulling the module rather than an ejector tab. 
The connector tab should be oriented in the top half of the frame. 

Verify that the module connector seats properly against the backplane.

Press the ejector tab or connector tab in to seat the module in place.

Install a module template overlay from the Instruction Manual if 
present.

Any 8900 Module

Power 

Supplies

(only)

0636-04r2

Frame Monitor or

8900NET Network 

Interface Module