Network Instruments WAN Probe Kit ユーザーズマニュアル
Installing the Interface Cards and Drivers 11
Make sure that the contacts of the network cards are correctly aligned with
the PCI bus slots on the motherboard. Push the network cards down
vertically until they are properly seated in the bus slots.
the PCI bus slots on the motherboard. Push the network cards down
vertically until they are properly seated in the bus slots.
9.
Tighten the locking screws on the fixing brackets until the cards are firmly connected
to the computer cover (or to the attachment provided for expansion cards).
to the computer cover (or to the attachment provided for expansion cards).
10. Close the computer cover and replace and tighten any screws.
11. Reconnect the power supply, following the safety instructions.
12. Turn the system on. The new hardware will be recognized differently depending on
whether you are running Windows 2000 or Windows XP. Refer to the appropriate
section that follows to complete the driver installation.
section that follows to complete the driver installation.
Updating the WAN and 10/100 Drivers
After you have installed the cards and turned on the computer, both Windows 2000 and
Windows XP will attempt to recognize and install drivers to match the new hardware.
Make sure that you have installed the Network Instruments Probe software; you must
supply a directory that the Network Instruments install program creates to the Found New
Hardware wizard.
Windows XP will attempt to recognize and install drivers to match the new hardware.
Make sure that you have installed the Network Instruments Probe software; you must
supply a directory that the Network Instruments install program creates to the Found New
Hardware wizard.
WAN Interface
10/100 Ethernet NIC