Namco Bandai Games spin the spin ユーザーズマニュアル
Page 32
5-1 Adjusting the Level Adjusters
When the machine is in it’s final position, lower the four level adjusters, with a
spanner, so that the castors are raised from the floor by approximately
5mm and the machine is level. Tighten the lock nuts with a spanner to
ensure that the level adjusters do not move.
spanner, so that the castors are raised from the floor by approximately
5mm and the machine is level. Tighten the lock nuts with a spanner to
ensure that the level adjusters do not move.
If the machine is installed on a smooth or shiny floor, it is recommended that
rubber pads are fitted under each adjuster to prevent the machine from moving
when being played.
rubber pads are fitted under each adjuster to prevent the machine from moving
when being played.
5-2 Fitting the Ball
1.
Remove the 2 security screws (M4x12), spring and flat washers and
remove the window retainers (B) from the front window.
remove the window retainers (B) from the front window.
2.
Remove the 3 security screws (M5x12) and remove the top retaining
bracket.
bracket.
3.
Remove the front window.
4.
Remove the rail holder, only fitted for shipping, and store it in a safe place
for re-use if the machine is moved at a future date.
for re-use if the machine is moved at a future date.
5.
Fit the ball in the location shown in the drawing opposite.
6.
Re-assemble the window and brackets in reverse order to above.