Electrolux OHV ユーザーズマニュアル

28

29

1)   Remove the four 5/16

"

 screws that hold panel to 

handle assembly. On re-assembly do not over 
tighten.

2)   Remove all of the knobs and the Headlight ( 

See Section 7.13 below).

3)   Carefully separate lock tab at each side and 

remove control panel from assembly.

4.) Reverse to reassemble.  Check picture for 

position of tabs and stops on back side of 
Console Panel.

Section  7.12 Auger Engagment Interlock 
-  When the auger  and the traction engagement  
levers are engaged at the same time, you can 
remove your hand from the auger lever and the 
auger will remain engaged as long as the traction  
lever is also held down.   This is to allow the 
operator to adjust the discharge chute direction 
without stopping.  If problems occur with interlock, 
check the spring and look for wear on the bracket. 
You will see this on the right with the console panel 
removed.

* Use two fingers to push up  on Headlight Bezel to 

release bottom tabs and remove Headlight.

* To remove harness connector, pull tabs on both 

sides outward while  pulling  connector from 
Headlight.

NOTE: Light is ‘on’ when engine is running.  There 

is not a switch.  See engine manufacturers 
manual for information on charging system.

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com