Electrolux OHV ユーザーズマニュアル

36

37

1)  Separate auger assembly from Powerhead 

assembly (See section 7.61)

3)  Use a 3/8

"

 ratchet with 6" extension inserted 

in square opening on the idler arm to 
release the tension on the belt.  Pull on 
ratchet to rotate idler arm.

4)  Remove defective belt and replace with new 

traction drive belt.

       NOTE: Idlers, Idler Brackets, and Springs  
       for both drive Belts are now accessable.

2)  Ensure that idler spring is in place before 

re-assembly. Put tape over the spring hook 
on the outside of housing to keep the spring 
in proper position.

5)  Re-attach auger housing to powerhead (see 

section 7.61 or section 7.32)

1)  Separate powerhead assembly from auger 

housing assembly (see section 7.61)

2)  Remove Traction Drive Belt ( Section 7.33 )
      from  engine pulley.
3)  Use traction drive belt to prevent drive 

pulley from turning remove 1⁄2” hex head 
bolt holding the pulley in place 

4)  Use antiseize compound before replacing 

Pulley and reinstall washer, bolt at 15-20 
Ft.Lbs., and belt. 

5)  Reassemble auger housing to powerhead 

assembly.

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com