Electrolux OHV ユーザーズマニュアル

38

39

1) Remove belt cover ( Sections 7.31 & 7.32).
2) Remove both belts from engine pulleys. See  
     page 20

3) Tape idler Spring to outside of  powerhead 
body.

4) Remove traction drive belt idler bracket, belt 
guide for auger drive, and engine pulleys.

5) Disconnect headlight wire harness on 
engine.

6) Position Snowthrower with front of auger 
down.

7) Remove Frame Bottom Pan (Section 7.42).
8) Remove Drive Plate Assy. (Section 7.43).

9) Place a piece of wood (15" long by 3/4" 
thick) between Engine and Pivot Support.

10) Use a 1/2" socket with 15" extension to 
remove the 4 engine mounting bolts.
11) Remove engine. 

12) Place new engine on side on pivot support 
for reinstallation.  A board about 3/4" thick 
placed across pivot support will help to position 
engine while starting self-tapping screws.  
Torque screws holding engine to chassis at 
25-30 Ft.Lbs.
13) Reinstall Drive Plate Assembly, 
(Section 7.45)
14)  Place wheels back on axles so the blower 
can be tipped back into operating position. 
Reinstall engine pulleys, idler bracket with idler 
pulley, belt guide, attach idler spring, and belts. 
Adjust Belt Guide as shown in Section 6.01.

NOTE: With Frame Bottom Pan off, the belts 
are accessible from the bottom for installation 
on pulleys.  Do not install  bottom Pan until 
belts are fully installed.
15) Reposition snow thrower with front of 
auger down.  Reinstall frame bottom pan.  
Tip snowthrower back to operating position. 
Reinstall belt cover.    

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com