Electrolux OHV ユーザーズマニュアル

44

45

CAUTION:  Only OEM shear bolts should be 
used.  Use of other hardware may result in se-
vere damage to the auger or the gearbox and 
result in expensive repairs.

28  179828      Shoulder Bolt, Auger
49  74780426  Screw, Hex Head

1)  Separate Auger Assembly from powerhead 

of Snowthrower (Section 7.61).

2)  Remove the 1⁄2” bolt and washers that hold 

the auger drive pulley in place using the 
belt to prevent pulley from turning.

3)  Remove the auger drive pulley from the 

impeller shaft. It may be necessary to use a 
gear puller for this. If so, it may help to put a 
small socket between the gear puller screw 
and the shaft.

4)  Using emery cloth, clean and smooth the 

surface of the shaft.

5)  Remove the right and left side bolts (3/8") 

that hold the auger bearings in place.

6)  Holding the Auger pull up to remove the 

impeller assembly from the auger housing. 
It may  be necessary to use a file to smooth 
edges of keyway on the shaft so the shaft 
will slide through the bearing.

7)  To replace the auger remove shear bolts 

and pull away from gearbox shaft.

8)  To replace impeller remove shear bolts and 

pull away from shaft.

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com