Electrolux OHV ユーザーズマニュアル

42

43

1)  Remove spring that attaches from the 

deflector to the pivot.

NOTE: If unit is not equipped with a remote 
deflector proceed to step 4
2)  Remove the nut and washer that secures 

the deflector cable to the deflector.

3)  Remove the nut, washer and bracket that 

secure the cable to the chute.

4)  Remove the 9/16" locknut and separate the 

cable assembly from the chute assembly.   
               The chute assembly will separate, 
be careful not to drop the chute onto the 
snowthrower.

5)  Reverse process to reinstall chute deflector.

1)  Remove spark plug wire from plug.
2)  Remove Deflector Chute (Section 7.51 

Chute Removal)

3)  Remove both 3/8

"

 screws that secure belt 

cover.  Remove belt cover.

4)  Place a chair or saw horse behind handle 

assembly for support after auger section is 
split.

5)  Remove both 9/16

"

 hex bolts that hold the 

powerhead and auger housing together.

To Reinstall:
7)  Place belt on auger pulley and use to lift 

auger assembly into position so that slotted 
bracket on auger housing are placed onto 
the rod at base of powerhead.

9)  Route auger belt around pulleys/guide. 

Check that belt is not caught on idler brkt.

10)Reinstall bolts to secure auger housing to 

the powerhead and belt cover.

11)Reinstall the chute assembly and plug wire.

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com