Zephyr ZGEE30AS290 オーナーマニュアル

www.zephyronline.com

Installation –

Installing the Hood

WARNING: Electrical wiring must be done by a qualified person(s) in accordance with all applicable codes and

standards. This range hood must be properly grounded. Turn off electrical power at service entrance before wiring.

1) Prepare electrical wiring and ducting in cabinet. Location of junction box and blower outlet can be found on page 8.

2) Unscrew the (10) screws from front panel and place

the panel aside, Fig.3. You will now have access to the

interrior of the range hood.

Fig.3

Fig.4

3) Open cabinet doors. Lift range hood and slide it through

the opening located in the bottom of the cabinet, Fig.4.

Make sure opening matches the dimensions on page 9,

Fig.1.

4) There are spring clips located on the left and right sides

of the hood body which will temporarily hold the hood in

place, Fig.5.

Fig.5

Fig.6

5) Secure upper brackets to left and right sides of hood

body by using (2) 3/16 x 3/8” screws for each bracket.

Fig.6. Make sure the (2) captive nut screw holes on

the bracket are facing downward. Note: Due to limited

workspace in 30” cabinets you will need to use a right

angle or 2” long Philips head screwdriver.