Zephyr ZGEE30AS290 オーナーマニュアル

6) Place lower installation brackets under upper installation  

    brackets located on left and right sides of hood body,  

    Fig.7.  Note: The wider portion of the lower installation  

    bracket should be at the bottom.

7) From inside the hood, secure (1) M4x8 screw into        

    each lower installation bracket.  The position of this  

    screw is adjustable to accomodate various cabinet       

    bottom thicknesses, Fig.8.  Do not fully tighten screw yet.

8) Install (2) 3/16x1” screws into the captive nuts of each     

    upper installation bracket. Tighten screws to adjust the  

    height of range hood until there is no gap between the  

    cabinet bottom and front edge of hood, Fig.9.  After hood  

    is positioned, fully tighten the lower installation bracket  

    screw from step 7, Fig.8-1.

9) A f ller panel is included to accomodate multiple cabinet  

    depths.  Inside the hood are (2) thumb screws located  

    on the left and right sides at the back of the hood,       

    Fig.10A. Turn each thumb screw clockwise to push       

    the f ller panel towards the wall, Fig.10B.  Tighten thumb  

    screws until f ller panel meets the wall and is secured in  

    place.  See hood specif cations on page 8 for supported  

    cabinet depths.