Zephyr ZGEE30AS290 オーナーマニュアル

Whether your hood is installed as an exhaust or purifying unit, a decorative mesh filter is fitted by the factory.  This 
mesh filter is intended to filter out residue from cooking.  It need not be replaced on a regular basis but is required to 
be kept clean.  After every 30 hours of use the Filter Clean Reminder function in the microprocessor will automati-
cally remind you by a flashing          when the mesh filter needs to be cleaned.   The filter can be cleaned by hand 
with non-abrasive soap or in a dishwasher.  A heavily soiled filter should also be soaked in grease cutting 
detergent prior to cleaning.

When        flashes on display, the mesh filter installed is 
required to be cleaned.  This will occur after every 30 
hours of use.

Reset the filter clean reminder timer when filter is cleaned 
and re-installed. With hood off,  press and hold        for 
approximately 5 seconds until        on display disappears      
.       . The filter clean reminder function is now reset 
and a new 30 hours elapse cycle is initiated.

F

Clean Filters

display < F > flashes

F

hold 5 sec.

display from  < F > to <    >

To Reset

F

F

F

When your hood is installed as a recirculating unit it must be fitted with a charcoal filter to purify exhaust and fumes 
from cooking and then recirculate the air within the home.  This charcoal filter must be replaced after every 120 hours 
of use.  The charcoal filter should never be cleaned or placed in a dish washer.

The charcoal filter replace reminder function in the microprocessor needs to be switched on.  When switched on, the 
microprocessor will elapse and count usage time.  When charcoal filter replacement is needed a flashing          will 
appear on the display.

C

With hood off, hold        for approximately 5 seconds.       
The display will change from        (exhaust mode)  to           
        (recirculating mode). This indicates that the elapse 
timer function is switched on and charcoal filter is being 
used.

When the display          starts flashing, the charcoal filter 
needs to be replaced.  Purchase replacement charcoal 
filters from Zephyr.

After charcoal filter is replaced, with hood off, press and 
hold        for apprimately 5 seconds until          on the 
display disappears         .  The filter change reminder is 
now re-set and a new 120 hour elapse cycle is initiated.

C

C

C

C

hold 5 sec.

display from  < - > to < C >

Set Mode

Set Mode

display < C > flashes

Change FIlter

C

hold 5 sec.

display from  < C > to <    >

To Reset

C