Frigidaire FFLE4033Q インストール手順

15

  1  Turn off power supply to outlet.
  2  Remove the screw securing the terminal block 

access cover on the back of the dryer.

  3  Install a UL-approved strain relief according to the 

power cord/strain relief manufacturer’s instructions 

in the power cord entry hole below the access 

panel. At this time, the strain relief should be 

loosely in place.

  4  Thread an UNPLUGGED, UL-approved, 30 amp. 

power cord, NEMA 10-30 type SRDT, through the 

strain relief.

  5  Attach the power cord neutral (center wire) 

conductor to the SILVER colored center terminal on 

the terminal block. Tighten the screw securely.

  6  Attach the remaining two power cord outer 

conductors to the outer, BRASS colored terminals on 

the terminal block. Tighten both screws securely.

7  Follow manufacturer’s guidelines for fi rmly securing 

the strain relief and power cord.

8  Reinstall the terminal block cover.

Neutral 

terminal

DO NOT remove 

internal ground in a 

3-wire system!

3-wire receptacle

(NEMA type 10-30R)

Neutral

Neutral

(center wire)

(center wire)

30 AMP

30 AMP

NEMA 10-30

NEMA 10-30

Failure to disconnect power source before servicing 

could result in personal injury or even death.

Do not make a sharp bend or crimp wiring/conductor 

at connections.

If moving dryer from a 4-wire system and installing it 

in a 3-wire system, move the internal ground from the 

center terminal back to the GREEN screw next to the 

terminal block.