Frigidaire FFLE4033Q インストール手順

16

  1  Turn off power supply to outlet.
  2  Remove the screw securing the terminal block 

access cover on the back of the dryer.

  3  Install a UL-approved strain relief according to the 

power cord/strain relief manufacturer’s instructions 

in the power cord entry hole below the access 

panel. At this time, the strain relief should be 

loosely in place.

  4  Thread an UNPLUGGED, UL-approved, 30 amp. 

power cord, NEMA 14-30 type ST or SRDT, through 

the strain relief.

  5  Disconnect the internal (WHITE) dryer harness 

ground wire from the (GREEN) ground screw next 

to the terminal block.

  6  Attach the ground (GREEN) power cord wire to the 

cabinet with the ground (GREEN) screw. Tighten 

the screw securely.

  7  Move the internal dryer harness ground (WHITE) 

wire to the terminal block and attach it along with 

the neutral (WHITE) power cord wire conductor 

to the center,  SILVER colored terminal on the 

terminal block. Tighten the screw securely.

  8  Attach the RED and BLACK power cord conductors 

to the outer, BRASS colored terminals on the 

terminal block. Tighten both screws securely.

  9  Follow manufacturer’s guidelines for fi rmly securing 

the strain relief and power cord. 

  10  Reinstall the terminal block cover.

Move internal ground 

(WHITE) wire to neutral 

(silver) terminal for 

4-wire system

Neutral 

terminal

BLACK

or RED

power wire

BLACK

or RED

power wire

WHITE

neutral wire

GREEN

ground wire

GREEN

ground screw

4-wire receptacle

(NEMA type 14-30R)

Neutral

Neutral

(WHITE wire)

(WHITE wire)

30 AMP

30 AMP

NEMA 14-30

NEMA 14-30

Ground

Ground

(GREEN wire)

(GREEN wire)

Failure to disconnect power source before servicing 

could result in personal injury or even death.

Do not make a sharp bend or crimp wiring/conductor 

at connections.