Zephyr ZSIE36ASES 使用とお手入れ

www.zephyronline.com

Display (speed level, delay off, filter clean/change)

1  POWER / DELAY OFF BUTTON
       Power Button Function
       -      Button will turn power on and off for entire hood (fan and lights).
       - Hood will remember the last speed and light level it was turned off at.
 

(Example: Press      Button to turn off hood when on fan speed 3 and lights on. Press      Button  

 

again and the hood will turn back on at speed 3 and lights on.)

       Delay Off Button Function
       - With the fan on press and hold the      Button for two seconds. The fan will change to speed 1 and the  
         5 minute delay off timer will start.                 
                      +                                          LEDs will illuminate and slowly blink in accordance with the time  
 

remaining until the fan and lights automatically turn off.

       - Pressing      Button while Delay Off Function is enabled will turn the hood off and cancel the Delay Off     
         Function.

       ACT Verification
       -  Airflow Control Technology (ACT) allows the installer to set the maximum fan CFM to align with local  
          codes and regulations. 
 

- To verify the maximum fan CFM:

 

         - With hood off, hold the      Button for two seconds. If all five fan speed indicators illuminate =  

 

           default maximum CFM.  If 3 fan speed indicators illuminate = 290 maximum CFM.

2  SPEED SELECTION BUTTON
       Fan Speed Decrease Button
       - Press this button to decrease fan speed. 3, 2, 1.
       - If fan is On Speed 1 and this button is pressed, fan will power Off.
       Fan Speed Increase Button
       - Press this button to increase fan speed. Fan On, 1, 2, 3.
       - If hood is Off and this button is pressed, fan will turn On Speed 1.

3  LIGHTS BUTTON
      - From off, press one time to power lights on. Press again to power lights off.

4  DISPLAY INDICATORS
     Mesh Filter Clean Reminder (always enabled)
     - After 30 hours of fan usage, the       button indicator will begin to slowly blink indicating it is time to  
       clean the mesh filters. 
     - To reset: With hood off: hold the      button for three seconds. All LED indicators will blink two times       
       confirming the 30 hour timer has been reset.