Zephyr ZSAM90C オーナーマニュアル

1.  Measure from range top to hood bottom and mark line A.  

(26” minimum from range top) .

2.  Plum and mark center line.

3.  Mark hood height line B. (9-1/2” from line A)

4.  Mark mounting spread from C/L. (9-7/8” on line B) 

5.  Fasten (2) M4 x 1-1/2” screws into studs on line B but 

do not tighten all the way.  Note: Wood blocking may 
need to be added behind the drywall if no studs are 
present.  Wall anchors may also be used but check 
local codes for compliance. Failure to use suitable 
wall anchors and screws to hold the weight of the 
hood could result in personal injury or damage to 
the cooking surface or counter.

6.  Remove the (2) aluminum mesh fi lters.

7.  Hang hood onto the mounting screws and hand tighten 

each screw. (Fig A) 

8.  Center and attach duct cover mounting bracket to wall 

just below the ceiling or soffi t using (2) M4 x 1” screws.

9.   Install electrical and duct work.  Seal duct work with 

aluminum duct tape.

10. Power up hood and check for leaks around duct tape.

11. Place telescopic duct covers onto hood and extend 

inner (top) duct cover upwards and secure to duct cover 
bracket using (2) M4 x 8 screws. Reinstall mesh fi lters.

   * If using hood in recirculating mode you must secure the 

air diverter plate onto wall before installing duct work and 
duct covers.  You will also need to install charcoal fi lters 
and brackets. Turn to page 10 for more details.

9-7/8”

9-

1/2

”

26” min.

6-

1/2

”

Cable Lock

A cable locking connector (not supplied) might 
be required by local codes.  Check with local 
requirements and codes, purchase and install 
appropriate connector if necessary.