Gaggenau VG424210CA インストール手順
![Gaggenau](https://files.manualsbrain.com/attachments/e11b1721784f5a70b2241df6162e1873b0047dc1/common/fit/150/50/907623d4f1c04dc47058b87de34aa5c17e5e17ba11fc088bd8a8ff8e8f30/brand_logo.png)
15
4
The low-setting nozzles are located in the gas
valve and are screwed in from the front. Turn the
plastic part on the gas valve so that the recess is
above the respective nozzle. Unscrew the nozzle
and pull it out with a small pair of pliers.
valve and are screwed in from the front. Turn the
plastic part on the gas valve so that the recess is
above the respective nozzle. Unscrew the nozzle
and pull it out with a small pair of pliers.
5
Fully screw in the new low-setting nozzles as
detailed in the table of nozzles.
detailed in the table of nozzles.
6
Slide the spindles onto the gas valve and firmly
tighten the locking screws. Fit and firmly tighten
the cover plates.
tighten the locking screws. Fit and firmly tighten
the cover plates.
Replacing the main nozzles
1
Detach the securing clips from the burner pipes.
Unscrew the burners and extract the burner
pipes. The electrode can be left connected.
Extract the burners from the burner pipes.
Unscrew the burners and extract the burner
pipes. The electrode can be left connected.
Extract the burners from the burner pipes.
2
Extract the nozzles from the burner pipes by hand
and extract the O-ring.
and extract the O-ring.
3
Check correct fitting of the O-ring in the new
main nozzles. Slide the nozzles onto the burner
pipes. Do not bend the burner pipes!
main nozzles. Slide the nozzles onto the burner
pipes. Do not bend the burner pipes!
4
Fit the burners onto the burner pipes. Fit the
burners. Screw down the burners.
burners. Screw down the burners.
5
After loosening the screw, adjust the outer
burner's air regulation sleeve to the correct
dimensions (see nozzle table - L1). Tighten the
screw again.
burner's air regulation sleeve to the correct
dimensions (see nozzle table - L1). Tighten the
screw again.
6
By turning or moving it, adjust the inner burner's
air regulation sleeve to the correct dimension
(see nozzle table - L2).
air regulation sleeve to the correct dimension
(see nozzle table - L2).
7
Fit the cooktop and screw it down evenly. Fit
burner parts and pot supports, paying attention to
correct positioning.
burner parts and pot supports, paying attention to
correct positioning.
8
Set the pressure regulator to the correct pressure
(see “Connect gas supply”).
(see “Connect gas supply”).
Checking functions after the conversion:
The flames are adjusted correctly if no yellow tips are
visible. They must not go out when switching over
swiftly from the high to the low setting.
visible. They must not go out when switching over
swiftly from the high to the low setting.
Note: Stick the adhesive label included with the
nozzle set over the rating plate of the appliance to
document the changeover to a different gas type.
nozzle set over the rating plate of the appliance to
document the changeover to a different gas type.
DF
DF
DF
DF
/
23(1
PP
PP
/