Frigidaire FGHF2366PF 使用とお手入れ

31

Your refrigerator is equipped with water filtering

system. The water filter system filters all

dispensed drinking water, as well as the water 

used to produce ice.

The water filter is located at the top right side of

the fresh food compartment.

To order your replacement filters, please visit our

online store at www.frigidaire.com/store, by calling 

toll-free at 877-808-4195, or by visiting the dealer 

where you purchased your refrigerator. Frigidaire 

recommends that you order extra filters when you

first install your refrigerator, and that you replace

your filters at least once every six months.
Here is the product number to request when

ordering:
  PureSource Ultra

TM 

Water Filter

  Part #ULTRAWF

In general, you should change the water filter every six

months to ensure the highest possible water quality.

Water Filter Status on the user interface prompts 

you to replace the filter after a standard amount of

water (200 gallons/757 liters for PureSource Ultra

)

 

has flowed through the system.
If your refrigerator has not been used for a period 

of time (during moving for example), change the 

filter before reinstalling the refrigerator.

Filter Cartridge

Do not use with water that is microbiologically 

unsafe or of unknown quality without adequate

disinfection before or after the system. Systems 

certified for cyst reduction may be used on

disinfected waters that may contain filterable cysts.
Test & certification results:

•  Rated Capacity - 200 gallons/757 liters for 

PureSource Ultra

ice and water filter

•  Rated service flow - .50 gallons per minute
•  Operating Temp: Min. 33° F, Max. 100° F
•  Maximum Rated Pressure - 100 pounds per 

square inch

•  Recommended Minimum Operating Pressure: 

30 pounds per square inch

It is not necessary to turn the water supply off 

to change the filter. Be ready to wipe up any

small amounts of water released during the filter

replacement.
  1  Turn Off the ice maker power switch.
 2  Remove the filter by pushing on the end/face

of the filter.

 3  Slide the old water filter cartridge straight out

of the housing and discard it.

 4  Unpackage the new filter cartridge. Using

the alignment guide, slide it gently into the 

filter housing until it stops against the snap-in

connector at the back of the housing.

 5  Push firmly until the cartridge snaps into

place (you should hear a click as the cartridge 

engages the snap-in connector).

  6  Press a drinking glass against the water 

dispenser while checking for any leaks at the 

filter housing. Any spurts and sputters that

occur as the system purges air out of the 

dispenser system are normal.

 7  After filling one glass of water, continue

flushing the system for about four minutes.

  8  Turn On the ice maker.
  9  Press and hold the Water Filter button on the 

Ice & Water Dispenser control panel for three 

seconds. When the display changes from Red 

to Green, the status has been reset.

The PureSource Ultra

TM 

ice and 

water filter system is tested and

certified to NSF/ANSI Standards 42 and

53 for the reduction of claims specified

on the performance data sheet.



When ordering your replacement filter, please

reorder the same filter type that is currently in

your refrigerator.