Frigidaire FGHB2866P オーナーマニュアル

14

After connecting the water supply, refer to “How to Prime 

the Water Supply System” for important information about 

priming an empty water supply system.
Your refrigerator’s water supply system includes several 

tubing lines, a water filter, a water valve, and a water

tank. To ensure that your water dispenser works 

properly, this system must be completely filled with

water when your refrigerator is first connected to the

household water supply line.

Steel

Clamp

Brass

Compression

Nut

Water Line

Water Valve

Bracket

Valve Inlet

Water Valve

Water line from household

water supply

(Include enough tubing in loop to allow

moving refrigerator out for cleaning.)

Ferrule

(Sleeve)

Plastic Water Tubing

to Ice Maker

Fill Tube

To Connect Water Supply Line To Ice Maker Inlet Valve
  1  Disconnect refrigerator from electric power source.
  2  Place end of water supply line into sink or bucket. 

Turn ON water supply and flush supply line until

water is clear. Turn OFF water supply at shutoff valve.

  3  Remove plastic cap from water valve inlet and 

discard cap.

  4  If you use copper tubing - Slide brass 

compression nut, then ferrule (sleeve) onto water 

supply line. Push water supply line into water valve 

inlet as far as it will go (¼ inch/6.4 mm). Slide 

ferrule (sleeve) into valve inlet and finger tighten

compression nut onto valve. Tighten another half 

turn with a wrench; DO NOT over tighten. See 

Figure 1.

  

If you use stainless steel tubing - The nut and 

ferrule are already assembled on the tubing. Slide 

compression nut onto valve inlet and finger tighten

compression nut onto valve. Tighten another half 

turn with a wrench; DO NOT over tighten. See 

Figure 1.

  5  With steel clamp and screw, secure water 

supply line (copper tubing only) to rear panel of 

refrigerator as shown.

  6  Coil excess water supply line (copper tubing only), 

about 2½ turns, behind refrigerator as shown and 

arrange coils so they do not vibrate or wear against 

any other surface. Do not kink tubing.

  7  Turn ON water supply at shutoff valve and tighten 

any connections that leak.

  8  Reconnect refrigerator to electrical power source.
  9  To turn ice maker on, lower wire signal arm (freezer 

ice maker) or set the ice maker’s On/Off power 

switch to the “On” position (fresh food ice maker).