Frigidaire FGHB2866P オーナーマニュアル

ページ / 33
17
IMPORTANT
Your ice maker is turned on at the factory so it can work 
as soon as you install your refrigerator. If you cannot 
connect a water supply, set the ice maker’s On/Off icon 
to Off and turn off the water supply valve; otherwise, 
the ice maker’s fill valve may make a loud chattering
noise when it attempts to operate without water.
IMPORTANT
On occasion, unusually small ice cubes may be noticed 
in the bucket or in dispensed ice. This could occur in 
normal operation of the ice maker. If you start seeing 
these more frequently, it may be an indication of low 
water pressure or the water filter needs to be replaced.
As the water filter nears the end of its useful life and
becomes clogged with particles, less water is delivered 
to the ice maker during each cycle. Remember, if it’s 
been six months or longer since you last changed your 
water filter, replace the water filter with a new one. Poor
quality household water may require the filter to be
changed more frequently.
IMPORTANT
Turning off the ice maker will disable the ice dispenser. 
You will still be able to dispense water.
AUTOMATIC ICE & WATER DISPENSER
NOTE
The water dispenser has a built-in device that shuts off the 
water flow after three minutes of continuous use. To reset
this shutoff device, simply release the dispenser paddle.
NOTE
The ice maker also has a built-in plastic signal bale arm 
that automatically stops ice production when the ice bin 
is full. This signal arm should not be used to manually 
stop the ice maker.
CAUTION
For proper dispenser operation, recommended water 
supply pressure should fall between 30 psi and 100 psi. 
Excessive pressure may cause water filter  
to malfunction.
Priming the water supply system
  1  Begin filling the tank by pressing and holding a
drinking glass against the water dispenser paddle.
  2  Keep the glass in 
this position until 
water comes out 
of the dispenser. 
It may take 
about  
1½ minutes.
  3 Continue 
dispensing water 
for about four 
minutes to flush
the system and 
plumbing connections of any impurities (stopping to 
empty the glass as necessary).
Ice maker operation & care
After the refrigerator is installed properly and has cooled 
for several hours, the ice maker can produce ice within 
24 hours. The ice maker will fill the ice bin from the rear.
You must dispense some ice to force the ice forward in 
the bin. This will allow the bin to fill completely.
Turning the fresh food ice maker on and off
Ice production is controlled by the ice maker’s On/Off 
icon on the control panel. Press and hold the “Ice Off” 
icon for three seconds to turn the ice maker “ON” or 
OFF”. The ice maker is turned off when the LED above 
the “Ice Off” icon is illuminated.
Using the ice maker after installation
Before making ice for the first time, be sure to prime the
water supply system. Air in new plumbing lines can result 
in two or three empty ice maker cycles. Furthermore, 
if the system is not flushed, the first ice cubes may be
discolored or have an odd flavor.
NOTE
Dispensed water is chilled. For colder water, add ice to 
cup or container before dispensing water.