XO XOE30 オーナーマニュアル
5.Ducted installation only
Tighten the Recirculation Plate and the outlet with screws.
Tighten the Recirculation Plate and the outlet with screws.
6. Ducted installation only
6.1 Remove 3 1/4″×10″ vertical, 3 1/4″×10″ horizontal, or 6” round knockout
plates as appropriate for your ducting method.
6.2 Attach 3 1/4″×10″ Damper/Duct connector (if using 3 1/4″×10″duct) or 6”
Damper/Duct connector (if using 6” round duct) over the Knockout openings.
INSTALLATION
WARNING: To reduce the risk of electrical shock, switch power off at service panel. Lock
or tag service panel to prevent power from being switched on accidentally.
1.Remove Electrical Wiring Box Cover from inside of hood and appropriate Electrical Power
WARNING: To reduce the risk of electrical shock, switch power off at service panel. Lock
or tag service panel to prevent power from being switched on accidentally.
1.Remove Electrical Wiring Box Cover from inside of hood and appropriate Electrical Power
Cable Knockout from top or back of hood.
2. Attach house power cable to hood using appropriate clamp.
3. Hold the hood in position under the cabinet. Tighten all 4 mounting screws completely to
3. Hold the hood in position under the cabinet. Tighten all 4 mounting screws completely to
secure the hood to the cabinet.
4.For ducted installation, connect ductwork to hood and use duct tape to make joints
secure and air-tight. Make sure the damper/duct connector enters ductwork and that the
damper opens and closes freely.
damper opens and closes freely.
5.Connect the house power cable to the range hood wiring: BLACK to BLACK, WHITE to WHITE
and GREEN or BEAR WIRE to GREEN GROUD SCREW.
6.Reinstall the Bottom Cover to the hood.
9
10