Dacor DDW24S インストール手順

Installation Instructions

Installation Preparation

WARNING

• Before working on wiring for any electrical

appliance, be sure the power has been

turned off at the breaker/fuse box. Place a

tag at the disconnect switch indicating that

you are working on the circuit.

• Moving this appliance requires two people.

Do not attempt to install or lift it alone.

• To prevent personal injury, wear hand

protection when moving this appliance.

• Do not allow any material, including the

hoses or electrical wiring to be directly behind

the dishwasher while pushing it into the

cutout opening. Carefully pull the slack out of

both hoses and the wiring from outside the

cutout during push back to prevent pinching.

An electric shock hazard or water damage

may result from pinched wires or hoses.

Damage due to improper installation is not

covered under warranty.

Adjust the Door Springs

Before installation, open the door to check the door

springs. If it tends to fall open or pull shut quickly

on its own, adjust the springs.
The door springs are on the sides of the

dishwasher. If adjustment is necessary, try making

small adjustments on only one side first.
1. Be sure the door is closed.
2. Grab the front end of the spring and pull it

up and forward to release it from the forward

mount.

3. To make small tension adjustments to the

spring, hold the back end of the spring with

one hand and turn the front part one or more

times. Turn it clockwise to increase spring

tension, counterclockwise to reduce tension.

4. To make larger tension adjustments to the door

springs, remove the back of the springs from the

dishwasher by turning them outwards.

Move them one hole farther back or forward, then

make small adjustments as outlined in step 3 as

necessary.

5. To reinstall the back end of the spring, hold it at

a right angle to the side of the dishwasher and

push the end into the hole, then turn the spring

in, toward the front of the dishwasher.

6. Reattach the front end of the spring by pulling it

up and forward to fasten it in the mount.

7. Open the door and check the spring tension

again. If necessary, make further adjustments.

Side of dishwasher

Door

spring

Increase spring

tension

Decrease

spring tension