Dacor DDW24S インストール手順

Level the Dishwasher

•  A level unit is very important to proper operation. 

Be sure to level the unit front to back and side 

to side.

•  Use caution when sliding the dishwasher on the 

floor. Even the plastic feet can cause damage to 

certain types of flooring.

The dishwasher comes with white plastic feet for the 

legs to help avoid damage to the kitchen floor when 

you slide it into place. Snap them onto the bottom of 

all three legs before leveling the appliance.
Do not attach the plastic feet if the installation space 

is the minimum required height.

to level the dishwasher:
1.  Position the dishwasher in front of the cabinet 

opening. Loosen the retaining nuts on the 

dishwasher’s three feet using a crescent wrench. 

Turn the nuts until they are as close to the floor 

as possible.

2.  Measure the height of the front and back of the 

cutout with a tape measure.

3.  Adjust the feet, until the front of the dishwasher 

measures 1/8” (3.0 mm) shorter than the cutout 

height.

Installation Instructions

4.  Open the door and pull the bottom rack out of the 

dishwasher. Check to make sure the dishwasher 

floor is level left to right using a level. Adjust the 

front legs as necessary. 

5.  Adjust the rear leg until the floor of the 

dishwasher is level front to back. 

6.  Tighten the rear retaining nut, but leave the front 

retaining nuts loose to allow for final leveling after 

the unit is pushed into place.

Connecting the Wiring

If the cord is not long enough, or if a hard-wire 

installation is needed, follow the steps below to 

complete the electrical connection. Otherwise skip 

to Installing the Unit in the Cabinet. NOtE: When 

doing a hard-wire installation, you must remove the 

supplied power cord.

•  Before starting this procedure, be sure the 

power is disconnected/turned off.

•  Make sure the water supply line, drain line and 

outside of the electrical cable do not touch any 

exposed terminals of the dishwasher wiring.

1.  Remove the toe kick brackets from the front of 

the electrical access panel, below the door.

2.  Remove the electrical access panel.
3.  Disconnect the factory installed power cord from 

the terminal block and 

ground connection screw 

inside the access panel. 

Remove the cord.

   continued...

Toe kick 

bracket

Electrical  

access panel

Catch

Terminal block 

location