Frigidaire FCRS201LFB オーナーマニュアル

4

Leave a one (1) inch space on all sides and the back of the 
cabinet for ease of installation, proper air circulation and 
electrical connections. DO NOT block the front grill on the lower 
front of your appliance. Sufficient air circulation is essential 
for the proper operation of your appliance. Choose a place 
that is near a grounded electrical outlet. For the most efficient 
operation, the appliance should be located where surrounding 
temperatures will not drop below 40ºF (5ºC) or exceed 110ºF
(43ºC). Additional compressor heaters are not recommended.

1.    Locate and align fixed caster (with brake lever facing 

front of unit - see Figure 3) over the same mounting 
holes from bracket in Figure 1 using six hex screws (3 for 
each caster). Secure the screws snug using a 3/8” open 
end wrench. Repeat this procedure for opposite corner. 
DO NOT OVERTIGHTEN.

1.    Remove and discard the screws shown in Figure 4 from 

each bottom corner using a 5/16” socket wrench.

2.    Locate and align swivel caster over the holes and install 

with two hex screws. Secure the screws snug using a 
3/8” socket wrench. 

3.    On the opposite side of the swivel caster plate, insert 

two carriage bolts through the compressor support rail 
and swivel caster plate. Use a lock nut on each bolt and 
tighten securely using a 9/16” socket wrench. See Figure 
5.

4.    Repeat the same procedure for the opposite rear corner.

5.    With the help of an assistant, carefully upright the unit

Reassemble the rear access guard with screws. 

Remove Screw Before 

Installing Caster

Repeat For 

Opposite Corner

Install caster using

(2) hex screws