Frigidaire FCRS201LFB オーナーマニュアル

6

Be sure to turn the temperature control to “OFF” and unplug the 
electrical cord. Wash the inside surface of the storage area with 
warm water and baking soda solution (about one tablespoon 
of baking soda per quart of warm water). Rinse thoroughly with 
clean, warm water and wipe dry. 

Wipe the cabinet exterior occasionally with a cloth dampened in 
mild detergent and water. Rinse and wipe dry with a soft cloth.  
Do not use razor blades or other sharp instruments that can 
scratch the appliance surface when removing adhesive labels. 
Any glue left from the tape can be removed with a mixture of 
warm water and mild detergent or touch the residue with the 
sticky side of tape already removed. DO NOT REMOVE THE
SERIAL PLATE.

This appliance is designed for efficiency with heavy foam 
insulation. However, there are things that the user can do to 
maintain the appliance in operating condition.

•    Do not operate the appliance any colder than necessary

to maintain safe, product storage temperatures.

•    Make sure the appliance is located to prevent direct

exposure to sunlight, air ducts, etc.

•    Keep the door closed except for normal use. Inspect the

door often to see that it self-closes and the gaskets are in 
good condition.

•    Do not overstock the product in the cabinet because it

will block the normal air flow.

•    Have at least annual inspections by a qualified service

company to see that the refrigerant charge is correct.

•    This appliance operates more efficiently in a cooler

ambient than in a hot ambient. Try to maintain an ambient 
below 80ºF (27ºC) and 65% RH (Relative Humidity) for
maximum efficiency.

Some models have a condensate pan in a fixed position located 
behind the toe grill. This must not be removed from under the 
cabinet. If the pan is removed, condensate will drop onto the 
floor.

DO NOT open the appliance lid unnecessarily if the appliance is 
off for several hours.

If a power failure occurs, pack seven or eight pounds of dry ice 
into the appliance every 24 hours. Look in the Yellow Pages 
under “Dry Ice”, “Dairies”, or “Ice Cream Manufacturers” for local 
dry ice suppliers. Always wear gloves and use caution when 
handling dry ice.

The Stainless Steel Door models are equipped with a 40 watt
bulb that lights up when the door is opened. If the bulb goes 
bad, replace with bulb of the same type and wattage. This is 
a special bulb with a shatterproof coating. Use only an NSF 
certified bulb of the same type and wattage which can be 
ordered from your Frigidaire Commercial Service Center by 
calling 1-866-738-1640.

Leave the appliance operating during periods of non-use of less 
than three (3) weeks.

If the appliance will not be used for several months:

•    Remove all food and unplug the power cord.

•    Clean and dry the interior thoroughly.

•    Leave the appliance door open slightly, blocking it open if

necessary, to prevent odor and mold growth.

When moving the appliance , follow these guidelines to prevent 
damage:

•    Disconnect the power cord plug from the wall outlet.

•    Remove foods, then defrost, and clean the appliance .

•    Secure all loose items such as base panel, baskets,

and shelves by taping them securely in place to prevent 
damage.

•    In the moving vehicle, secure appliance in an upright

position to prevent movement. Also, protect outside of 
appliance with a blanket or similar item.

•    The Glass Door Refrigerator is equipped with a 17 watt

fluorescent lamp. A ballast – lamp mismatch may result 
in poor or no lighting.

•    If the lamp fails, replace with a lamp of the same 

type and wattage. Also, replace a lamp that flickers 
continuously. This could damage the ballast.

•    Turning the light off, when not in use, will save energy. 

However, frequent ON-OFF cycling will reduce the lamp 
life.

•    Use only NSF certified lamp which can be ordered from 

your Frigidaire Commercial Service Center by calling 
1-866-738-1640.