Electrolux E30MC75JSS オーナーマニュアル

ページ / 76
20
Setting for Best Results
Removing and replacing 
extendable oven racks
Installing standard oven 
racks
Always arrange the oven racks when the oven is 
cool (prior to operating the oven). 
Always use oven mitts when using the oven.
Always arrange the oven racks when the oven is 
cool (prior to operating the oven). 
Always use oven mitts when using the oven.
Do not try to install the extendable oven racks into 
the standard oven rack levels (or rack support).
Do not try to install the standard oven rack on the 
sliders.
Installed on 
sliders
To remove 
from sliders
To place on 
sliders
Pull oven rack forward and lift 
it up off the oven rack slider.
To install, take a standard oven rack with the handle 
in front of you and the stoppers looking down. Align 
the rear of the rack on the level you want to install 
it, then push on the rack to slide it in the level until it 
stops. 
This stopper will prevent the rack to bump on the 
convection fan cover at the end of its course.
This “safety stopper” will stop the rack when you 
pull it out. This will prevent you to accidentally pull 
the rack too far and make it fall.
Must point
upward
FRONT
BACK
To remove an oven rack, pull the rack forward. 
Lift up the rack off the oven rack slider. To install 
an oven rack, locate the two pinholes in the small 
plates at the front corners of the rack. Place the 
rack on the side sliders and drop the pin holes over 
the pins on the sliders.