Electrolux UR15IM20RS オーナーマニュアル

5

  1  Position the unit on a flat, level 

surface, capable of supporting the 

entire weight of the unit. Remember 

that the unit will be significantly 

heavier once it is fully loaded.

  2  The surrounding air temperature must 

be at least 50°F (10°C) but must not 

exceed 110°F (43°C).

  3  The unit must not be located near 

heat-generating equipment or in 

direct sunlight.

  4  The unit must be located to allow 

clearance for water, drain and electrical 

connections in the rear of the ice maker.

  5  Connect the unit to a grounded and 

polarized 115 VAC, 60 Hz, 15 A 

circuit (normal household current).

  6  Avoid connecting the unit to a Ground 

Fault Interrupter (GFI). GFIs are prone 

to nuisance tripping which will cause 

the unit to shut down. GFIs are 

generally not used on circuits which 

power equipment that must run 

unattended for long periods of time.

  7  The unit must be installed according 

to your local codes and ordinances.

  8  Position the unit to allow free air flow 

through the front grille (Figure 2).

  9  Wipe out inside of unit with a damp 

cloth.

It is extremely important that the unit is 

level. If it is not level, the ice mold will not 

fill evenly. This can cause a reduction in ice 

rate, uneven sized cubes or water spilling 

into the storage area which will cause 

the ice in the bin to melt pre-maturely. 

Remember that floors near drains have a 

tendency to slope towards the drain.

ELECTROCUTION HAZARD!
Electrical Grounding Required. This 

appliance is equipped with a three 

prong (grounding) polarized plug 

for your protection against possible 

shock hazards.
•  NEVER remove the round 

grounding prong from the plug.

•  NEVER use a two-prong 

grounding adapter.

•  NEVER use an extension cord to 

connect power to the unit.

Where a two-prong wall receptacle is 

encountered or a longer power cord is 

required, contact a qualified electrician 

to have it replaced in accordance with 

applicable electrical codes.

The door of this unit is not reversible 

but a separate model is available with a 

door that swings open in the opposite 

direction. Electrolux stainless steel 

models require a minimum 2-3/4 inch 

handle clearance when installed against 

a wall or cabinet that extends beyond 

the front edge of the unit (Figure 1).

Figure 1

Cabinet

or Wall

2 - 3/4"

Clearance

Needed

Door

Swing

Figure 2

Intake

Exhaust

This unit is designed for indoor use only.