Electrolux EWMED7CJSS インストール手順

A wiring diagram and technical data sheet are 
located inside the dryer console.

Grounding type

Grounding type
wa

wall receptacl

ll receptacle

Po

Power cord with

wer cord with

3-prong 

3-prong  gr

grounded plug

ounded plug

Be sure the power is off at a circuit breaker/fuse 
box before plugging the power cord into an outlet.

Connect the exhaust duct to the outside exhaust 

1. 

system (see pages 5 through 7). Use of a 4” (102 
mm) clamp (item A)  is recommended to connect 
the dryer to the exhaust vent system. Use metal 
foil tape to seal all other joints. 

Carefully slide the dryer to its fi nal position.  

2. 

Adjust one or more of the legs until the dryer is 
resting solidly on all four legs. Place a level on 
top of the dryer. The dryer MUST be level and 
resting solidly on all four legs. Rock alternating 
corners to check for stability. Remove and 
discard door tape.

Plug the power cord into a grounded outlet.

3. 

Turn on the power at the circuit breaker/fuse 

4. 

box.

Read the 

5. 

Use & Care Guide provided with 

the dryer. It contains valuable and helpful 
information that will save you time and money.

See the next page about performing a brief, 

6. 

helpful “Installation Cycle” for your new dryer.

If you have any questions during initial 

7. 

operation, please review the “Avoid Service 
Checklist” in your Use & Care Guide before 
calling for service.

Place these instructions in a location near the 

8. 

dryer for future reference.