Epson SP4900DES ユーザーズマニュアル
Manual cut method
If you set Off or Roll Paper / No Cut on the printer
driver or control panel, you can cut the paper after
printing using the following procedure.
driver or control panel, you can cut the paper after
printing using the following procedure.
A
While watching the inside of the printer through
the window in the printer cover, press the d
button to feed the roll paper and adjust the
cutting position to the
the window in the printer cover, press the d
button to feed the roll paper and adjust the
cutting position to the
mark on the inside
of the printer on the right-hand side.
Tip:
The minimum length of paper you can cut with the
built-in cutter is fixed to 80 or 127 mm and cannot
be changed. The length is 210 mm when the
optional SpectroProofer is installed. If the cutting
position is shorter than the shortest length above,
the paper has to be automatically fed to that length
thus a margin will have to be left. Cut off the margin
with a cutter sold at a store.
The minimum length of paper you can cut with the
built-in cutter is fixed to 80 or 127 mm and cannot
be changed. The length is 210 mm when the
optional SpectroProofer is installed. If the cutting
position is shorter than the shortest length above,
the paper has to be automatically fed to that length
thus a margin will have to be left. Cut off the margin
with a cutter sold at a store.
B
Press the X button. When the confirmation
message is displayed on the screen, use the d
button to select Cut, and then press the Z
button.
message is displayed on the screen, use the d
button to select Cut, and then press the Z
button.
The paper is cut by the built-in cutter.
Tip:
If the roll paper cannot be cut by the built-in cutter,
press the d button to feed the paper to a position
where you can cut it manually.
If the roll paper cannot be cut by the built-in cutter,
press the d button to feed the paper to a position
where you can cut it manually.
Removing the roll paper
Remove the roll paper from the printer after printing
and store it. If the roll paper is left in the printer, the
roller of the paper presser may leave a mark on the
surface of the paper.
and store it. If the roll paper is left in the printer, the
roller of the paper presser may leave a mark on the
surface of the paper.
A
Make sure the printer is on.
B
Open the roll paper cover.
C
Press the Y button to release the paper presser.
The roll paper is rewound automatically after
cutting or if it is standing by. The printer starts to
print a barcode if Remaining Paper Setup is set
to On from the Menu. When barcode printing is
complete, the paper rewinds.
cutting or if it is standing by. The printer starts to
print a barcode if Remaining Paper Setup is set
to On from the Menu. When barcode printing is
complete, the paper rewinds.
If it does not rewind automatically, rotate the
flanges in the opposite direction to rewind.
flanges in the opposite direction to rewind.
Note:
Press the Y button when removing the roll paper.
Press the Y button when removing the roll paper.
If you do not press the Y button when removing the
roll paper, the barcode is not printed even if
Remaining Paper Setup
roll paper, the barcode is not printed even if
Remaining Paper Setup
is set to On from the
Menu, and you cannot manage the roll paper
information.
information.
D
Hold both ends of the spindle and lift up from the
spindle holder.
spindle holder.
Epson Stylus Pro 4900/4910 User's Guide
Basic Operations
32