Mitsubishi Electronics DX-TL16U ユーザーズマニュアル

Digital Video Recorder

Highlight the box beside Transaction End, and press the

button. Use the virtual keyboard to enter the

Transaction End string. Refer to the device manufacturer’s documentation for the text string that the device
sends when a transaction ends.

Highlight the more line(s) box, and press the

button. Select the number of additional lines of text that

you want the DVR to record. You can choose from 0 to 10.

Highlight the box beside Line Delimiter, and press the

button. Use the virtual keyboard to enter the

character(s) that the device uses to indicate the end of a line. Special characters can be created using ^ and a
capital letter; e.g., ^J for NL (New Line), ^M for CR (Carriage Return). Refer to the device manufacturer’s
documentation for Line Delimiter character(s).

Highlight the box beside Ignore String, and press the

button. Use the virtual keyboard to enter any

strings of text that you want the DVR to ignore. Refer to the device manufacturer’s documentation for
text strings that the device sends during transactions, so you will know which ones you do not want recorded.

Highlight the Case Sensitive box, and press the

button to toggle between On and Off. Refer to the

device manufacturer’s documentation to determine if the text strings are Case Sensitive. If the device
distinguishes between upper and lower case letters, make certain the Case Sensitive box is turned On.

Highlight the box beside Time Out, and press the

button. Set the length of time to wait for the new

text string. The DVR will consider a transaction complete if no new text strings are entered between the
last text input and the dwell time out. You can adjust the Time Out dwell from 5 seconds to 15 minutes.

The DVR can be set to react to text input. Highlighting the box under the Actions heading and pressing
the

button allows you to set up event actions for alarm input.

 Record ─ Select the cameras that you want the DVR to record whenever it detects text input.
 Alarm-Out ─ Select between Alarm Output and Beep (DVR’s internal buzzer) that you would like to activate

and to sound whenever the DVR detects text input.

 Notify ─ You can toggle the individual notification items On and Off by highlighting that item and pressing

the

button. Highlight OK and press the

button to accept your changes.

 PTZ ─ Select the preset position for each PTZ camera, where you want PTZ cameras to move to whenever

the DVR detects text input.

 Spot Monitor ─ Associate a camera with the Spot monitor. The DVR will display the associated camera on

the Spot monitor whenever it detects text input.

NOTE: For the Record action, the camera you select should be set to the Event or Time & Event
recording mode in the Record Schedule setup screen.

NOTE: Recording video of text-in events might NOT be made properly when the recording speed
is set too low.

NOTE: For the Alarm-Out action, the alarm output and beep you select should be set to the Event
mode in the Alarm-Out setup screen (Schedule tab).

NOTE: For the Notify action, the notify item you select should be enabled in the Notification setup
screen and the DVR should be registered in the DX-PC For View (Remote Administration System).

You can save your Text-In changes by highlighting Save and pressing the

button. Selecting Cancel

exits the screen without saving the changes.