Chariot Carriers Corsaire XL ユーザーズマニュアル

Lay both the hiking arms with shoulder harness and waist strap 
as shown in the “Supplied as standard” illustration in front of the 
carrier. The waist strap must be attached to the insides of both 
arms.

Insert each arms into the VersaWing 2.0 until the vertical holes 
in the arms and VersaWing 2.0 are aligned with each other. 
The arms  should now protrude about 2 cm / 3/4 inch out of the 
rear side of the VersaWing 2.0.

Now secure the arms by inserting the security pin from above 
through the vertical hole in the arm and VersaWing 2.0 until it 
stops. Lock the security pin by looping the spring clip over the 
pins end that protrudes underneath the VersaWing 2.0.

DANGER

Always make sure that the security pin of the hiking arms 
are properly inserted to prevent the carrier from accidentally 
rolling away. You run the risk of an accident!

The shoulder strap, which is attached in a similar way to that 
of a backpack, can be adjusted in three positions: at the chest 
strap at the front, 

and at the waist strap itself.

at the back strap on top for adjusting the height of the waist strap

TIP

The holes in the hiking arms are larger than the security pins, 
so that the arms can rotate slightly around their longitudinal 
axes (in order to adapt to narrow or wide hips, and single and 
double width carriers).