Chariot Carriers Chariot Baby Seat ユーザーズマニュアル

First guide the
bungee cord supplied 
through the lateral flaps 
that are at the bottom 
towards the front and 
pull it very tight.
When viewed from the 
inside of the transpor-
ter, the bungee cord 
and flaps should be 
positioned in front 
of the vertical frame 
tubes. 

Thread the end of the strap as 
shown in the above illustration 
through the fastener in the baby 
seat and gently pull the strap 
tight.

Illustration A

Place the baby seat in the 
trailer as shown in the above 
picture.

Start with the strap that points 
outwards at the front of the 
baby seat.
Thread it down in front of the 
telescopic tube.

Thread the strap through the flap 
at the bottom – the bungee cord 
is pulled through this as well. Now 
once again, in front of the teles-
copic tube, pull it upwards again.

Fitted baby seat ready to use in the centre and side position:

Finally pull all fastening straps tight. (If necessary the trailer body will need to be opened out again 
beforehand.)
If you want to adjust the seat to a flatter position, loosen both of the top fastening straps and pull the 
other four straps tight. If you want an adjustment of greater incline, the procedure is the same but reversed.