Chariot Carriers Chariot Baby Seat ユーザーズマニュアル

Start by securing the straps at the front end of the baby seat.

Thread the end of the strap as 
shown in the above illustration 
through the fastener in the baby 
seat and gently pull the strap 
tight.

Illustration A

In the centre of the trailer seat 
backrest, there are two straps 
for further securing of the baby 
seat.

Pull both straps as in 
illustration A through the two 
fasteners at the rear of the 
baby seat and pull them tight.

Finally connect the fastex 
buckles on the underside of the 
baby seat with the buckles on 
the lap belt of the side chosen. 
Pull the lap belt ends equally 
tight, so that the baby seat 
does not tip to one side.

Thread both straps as shown 
above down in front of the 
telescopic tube.

Lay the belts around the 
bungee cord and pull them 
back up also in front of the 
telescopic tube.

On the Corsaire XL and Captain XL models it is important to 
ensure that the baby seat is set high enough and under enough 
tension, so that neither the baby’s bottom nor its back will come 
into contact with the trailer seat as a result of jolts during travel. 
Once all straps have been pulled tight, the front padding should 
sit more or less vertical over the telescopic tube.