Zebra 105925G-002 ユーザーズマニュアル
64
Zebra P110i / P110m / P120i Card Printers Service Manual
980584-001 Rev. A
4.2 Troubleshooting Procedures
4.2.1
General Issues
The table below offers causes and solutions to symptoms related to improper operation. Check
the table when experiencing any loss of operation or print quality.
the table when experiencing any loss of operation or print quality.
Problem / Description
Cause / Solution
The LCD Panel displays OUT OF
CARDS message.
CARDS message.
1. Check for cards in the card feeder. If no cards
are present, load cards.
2. Press the Control Button for one second. The
printing job will restart.
The LCD Panel displays OUT OF
RIBBON message.
RIBBON message.
1. Check the ribbon. Replace if defective or
entirely used.
2. Ribbon will automatically synchronize and
printing will restart with a new card.
The LCD Panel displays
MECHANICAL ERROR
message.
MECHANICAL ERROR
message.
1. Check that you are using the correct card type
(see Technical Specifications).
2. If two cards are fed into the printer at the
same time:
Open the Lid and remove the Ribbon
Cartridge, empty the Card Feeder, and pull
out the jammed cards. Replace the Ribbon
Cartridge.
Cartridge, empty the Card Feeder, and pull
out the jammed cards. Replace the Ribbon
Cartridge.
Remove cards from Card Feeder, separate
them as shown in Loading Cards in
them as shown in Loading Cards in
, and replace.
3. Check that ribbon is loaded correctly.
The LCD Panel displays
ENCODING ERROR message.
ENCODING ERROR message.
1. Check that you are using the correct magnetic
card type (for low or high coercivity encoding).
2. Verify command syntax.
3. Contact Zebra technical support.
The LCD Panel displays INSERT
CARD message with cards in the
Card Feeder.
CARD message with cards in the
Card Feeder.
1. Printer may be in the Single Feed mode.
Change mode.
The LCD Panel displays CLEAN
PRINTER message.
PRINTER message.
1. Printer cleaning required (see
).