KitchenAid KFRU368T ユーザーズマニュアル

Copies of the standards listed above may be obtained from:

CSA International
8501 East Pleasant Valley Rd.
Cleveland, Ohio 44131-5575

National Fire Protection Association
One Batterymarch Park
Quincy, Massachusetts 02269

1. Make gas connections.

A combination of pipe fittings must be used to connect the  
grill to the existing gas line.

■

If local codes permit, use an outdoor flexible stainless 
steel tubing gas connector, design-certified by CSA 
International,  to connect the grill to the rigid gas supply 
line. A 

⁵⁄₈" diameter line is recommended. Using a wrench 

to tighten, connect the gas supply to the grill. 

Use pipe-joint compound on all non-flared male threads. 
Do not kink or damage the flexible connector when 
moving the grill.

■

Pipe-joint compounds suitable for use with Natural gas 
must be used. Do not use TEFLON

®†

 tape.

2. Open the manual shutoff valve in the gas supply line. The 

valve is open when the handle is parallel to the gas pipe.

3. Test all connections by brushing on an approved 

noncorrosive leak-detection solution. Bubbles will show a 
leak. Correct any leak found.

4. Go to “Check and Adjust the Burners” section.

1. Plug into a grounded 3-prong outlet.

■

Unpack grill. Remove all packaging materials and remove grill 
from carton.

■

Move grill close to desired outdoor location.

■

Open the hood.

1. Cut the tiedowns holding the grates together.

2. Remove rotisserie skewer (on some models), warming shelf 

and grill grates from inside the grill and remove packaging 
material.

3. Remove foam block and wrap from inside the grill.

4. Replace the grill grates.

†®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.

A

B

C

D

A

B 

A

B