KitchenAid KFRU368T ユーザーズマニュアル

Plug in Grill

1. This built-in outdoor grill comes with a power transformer

plug assembly for the grill lights and igniter. Plug in the single-
prong plug in the receptacle on the left underside of the grill.

2. Plug into a grounded 3-prong outlet.

3. Gently slide grill completely into outdoor enclosure.

4. Now go to the “Check and Adjust the Burners” section.

If Converting to LP Gas

IMPORTANT: A 20 lb LP gas fuel tank must be purchased
separately.

IMPORTANT: The gas pressure regulator/hose assembly
supplied with the conversion kit must be used. Replacement gas
pressure regulator/hose assembly specific to your model, is
available from your outdoor grill dealer.

To Install the 20 lb LP Gas Fuel Tank:

1. Install the 20 lb LP gas fuel tank into the compartment below

the grill.

2. Screw the gas pressure regulator/hose assembly to the 20 lb

LP gas fuel tank as shown.

3. Turn on the gas supply. Wait a few minutes for gas to move

through the gas line.

4. Test all connections by brushing on an approved

noncorrosive leak-detection solution. Bubbles will show a
leak. Correct any leak found.

5. Go to “Check and Adjust the Burners” section.

A. Single-prong plug

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,
fire, or electrical shock.

WARNING

A. 20 lb LP gas fuel tank
B. Gas pressure regulator/hose assembly

WARNING

Explosion Hazard

Use a new CSA International approved “outdoor”
gas supply line.

Securely tighten all gas connections.

If connected to LP, have a qualified person make sure
gas pressure does not exceed 11” (28 cm) water
column.

Examples of a qualified person include:

licensed heating personnel,
authorized gas company personnel, and
authorized service personnel.

Failure to do so can result in death, explosion, or fire.