3D Innovations NC60 ユーザーズマニュアル

❖

Secure and proof jobs that have been submitted to the 
printer are stored as processed, ready-to-print files on the 
Hard Disk Drive. These jobs can be printed (or deleted) 
through the Password Menu where you enter the 4-digit 
password for the job or jobs to be printed. Procedures for 
printing or deleting these jobs are listed in Table 1.7 on 
page 1-23.

The secure or proof job is placed at the top of the print 
queue, and will print following completion of the 
currently printing job. If more than one job is released, 
jobs are placed on the print queue in the order released. 
Secure or proof jobs having the same priority are printed 
on a first released basis. 

Secure printing delays printing of a job until a password 
associated with the job is entered at the printer’s Control 
Panel. Entering the password at the Control Panel will 
provide access to only those jobs sent with that password.

Secure jobs are normally created in PCL and PostScript by 
choosing the feature in a driver. When not using a driver 
with this feature, secure jobs may also be created by 
preceding the job with the following PJL commands:

@PJL XSECUREJOB 
@PJL XJOBPASSWORD = "number"

These commands must be immediately followed by a 
standard PJL “JOB” command that includes the 
“jobname.”