3D Innovations NC60 ユーザーズマニュアル

❖

Proof printing lets you print a single copy of a multiple 
copy job. You assign a password and copy count at your 
workstation or computer before printing. The first set is 
printed immediately. You can then go to the printer and 
proofread (proof) the first set. Depending on the outcome 
of the proofing, you can then decide either to continue 
printing the remaining sets or to delete the job by 
entering the password at the printer’s Control Panel.

Proof jobs, if not sent by a driver with the proof job 
feature, may be invoked in both PCL and PostScript by 
preceding the job with the following PJL commands:

@PJL XPROOFJOB 
@PJL XJOBPASSWORD = "number"

These commands must be immediately followed by a 
standard PJL “JOB” command that includes the 
“jobname.”

The printer continues processing all subsequent data as 
part of the proof job of name “job name.” The proof job is 
stored with name “job name” and associated with the 
password defined in the PJL XPASSWORD command. The 
proof job ends when the PJL End of Job command is 
received (i.e., @PJL EOJ). The “EOJ” command should be 
followed by a UEL.