3D Innovations NC60 ユーザーズマニュアル
Upgrading the Printer Software
4-28
❖
DocuPrint NC60 System Administrator Guide
Procedure E
MACINTOSH – XEROX PRINTER UTILITY
Once the upgrade process has begun do not power
off your printer!
off your printer!
1
Print a Configuration Sheet and a Diagnostics Page.
Keep these pages for future reference. For directions on
doing this, refer to Table 1.20 on page 1-101.
Keep these pages for future reference. For directions on
doing this, refer to Table 1.20 on page 1-101.
2
Launch the Xerox Printer Utility.
3
Select the NC60 printer to upgrade in PostScript Printers
list.
list.
4
Select Send.
5
Locate the upgrade file.
6
Select Open to send the upgrade file to the printer.
7
The Xerox Printer Utility will send the upgrade file to the
printer. The upgrade should take less than 10 minutes.
printer. The upgrade should take less than 10 minutes.
8
To see if your upgrade was successful, see the section
“Determining a Successful Upgrade” (page 4-20). If
successful, follow the instructions in the section “After the
Upgrade” (page 4-20). For problems consult the section
“General Troubleshooting” (page 4-32).
“Determining a Successful Upgrade” (page 4-20). If
successful, follow the instructions in the section “After the
Upgrade” (page 4-20). For problems consult the section
“General Troubleshooting” (page 4-32).