Liebherr 110309 7084282 - 01 ユーザーズマニュアル

u

Detach the connecting cable from the rear of the appliance,

removing the cable holder at the same time because other-

wise there will be vibratory noise!

After installation:

u

Remove  the  protective  film  from  the  decorative  trims  and

drawer fronts.

u

Remove all transit supports.

u

Risk of damage due to condensate!

If your appliance is not a Side-by-Side (SBS) appliance:

u

do not install the appliance directly alongside a further refrig-

erator/freezer.

u

Always see to good ventilation at the installation site.

Danger of suffocation due to packing material and plastic film!

u

Do not allow children to play with packing material.

The packaging is made of recyclable materials:

-

corrugated board/cardboard

-

EPS moulded parts

-

polythene bags and sheets

-

polypropylene straps

u

Take the packaging material to an official collecting point.

Risk of damage to the electronic control system!

u

Do not use stand-alone inverters (conversion of d.c. to a.c./

three-phase) or energy saving plugs.

Fire and overheating hazard!

u

Do not use extension cables or multiple socket outlets.

The type of current (alternating current) and voltage at the instal-

lation site have to conform with the data on the type plate  (see

Appliance at a glance).

Connect the appliance only with a properly installed

socket outlet with earthing contact. The socket outlet

must be fused with 10 A or higher.

u

Check the electrical connection.

u

Clean the appliance  (see 6.3) .

u

Plug in the power plug.

u

To switch on the entire appliance it is necessary only to switch

on the freezer compartment.

Put the appliance into operation about 2 hours before first loading

food to be frozen.
Do  not  load  food  to  be  frozen  before  the  temperature  display

reads -18 °C.

u

Press On/Off button, freezer compartment

 Fig. 2 (3)

.

w

The refrigerator compartment temperature display shows the

set temperature.

w

The freezer compartment temperature display and the alarm

button  flash  until  the  temperature  is  sufficiently  cold.  If  the

temperature is above 0 °C, dashes flash. If it is below, the

current temperature flashes.

u

Press On/Off button, refrigerator compartment

 Fig. 2 (11)

.

w

The interior light is on when the door is open.

w

The temperature displays shine. Refrigerator and BioFresh

compartment and freezer compartment are switched on.

u

Always pay attention to good ventilation.

u

Keep the time the appliance is open to a minimum.

u

Store food logically.

u

First cool warm food to room temperature before storing it .

u

Defrost frozen food in the refrigerator.

You can adjust the brightness of the temperature display to the

light conditions of the room in which the appliance is installed.

The  brightness  is  adjustable  between  h1  (no  illumination)  and
h5 (maximum luminosity).

u

To  activate  the  setting  mode:  press  the  SuperFrost  button

Fig. 2 (2)

 for about 5 s.

w

The display indicates c.

w

The SuperFrost button flashes.

u

Using the Up setting button, freezer compartment

 Fig. 2 (5)

 or

Down setting button, freezer compartment

 Fig. 2 (4)

, select

h.

u

To confirm: briefly press the SuperFrost button

 Fig. 2 (2)

.

u

To  make  the  display  brighter:  press  Up  button,

freezer compartment

 Fig. 2 (5)

.

u

To  make  the  display  darker:  press  Down  button,

freezer compartment

 Fig. 2 (4)

.

u

To confirm: press SuperFrost button

 Fig. 2 (2)

.

w

The brightness is adjusted to the new value.

u

To deactivate the set-up mode: press On/Off button, freezer

compartment

 Fig. 2 (3)

.

u

Wait for 5 minutes.

w

The temperature is indicated again in the temperature display.

The child-proofing function enables you to make sure that the

appliance is not inadvertently switched off by playing children.

u

To  activate  the  setting  mode:  press  SuperFrost  button

Fig. 2 (2)

 for about 5 s.

w

The display indicates c.

w

The button SuperFrost flashes.

u

Briefly press the SuperFrost button

 Fig. 2 (2)

 to confirm.

u

To switch on: Using the Up setting button, freezer

compartment

  Fig.  2  (5)

  or  Down  setting  button,

freezer compartment

 Fig. 2 (4)

, select c1.