Frigidaire MODEL #S ユーザーズマニュアル

4

Í

The exterior walls of the beverage cooler may become 

quite warm as the compressor works to transfer heat 

from the inside.  Temperatures as much as 30° F 

warmer than room temperature can be expected.  For 

this reason it is particularly important in hotter climates 

to allow enough space for air circulation around your 

appliance.

The beverage cooler must have all bottom corners resting 

firmly on  solid floor. The floor must be strong enough 

to support a fully loaded beverage cooler. NOTE:  It is 

Very Important for your appliance to be level in order to 

function properly.  If the appliance is not leveled during 

installation, the door may be misaligned and not close 

or seal properly, causing cooling, frost, or moisture 

problems.    

After removing all interior and exterior packaging 

materials, use a carpenter’s level to level the beverage 

cooler from front-to-back. Adjust the leveling legs in 

front, ½ bubble higher, so that the door closes easily 
when left halfway open.

Wash any removable parts of the beverage cooler 

interior, and exterior with mild detergent and warm 

water. Wipe dry. Do not use harsh cleaners on these 

surfaces.
Do not use razor blades or other sharp instruments, 

which can scratch the appliance surface when 

removing adhesive labels. Any glue left from the tape 

can be removed with a mixture of warm water and 

mild detergent, or touch the residue with the sticky 

side of tape already removed. Do not remove the 

serial plate.

Important Safeguards: Do not store food in your wine 

cooler as interior temperature may not get cool enough 

to prevent spoilage. In summer months or areas of high 

humidity,  the glass door may build up moisture. To 

remove the moisture, wipe it away.

Place handle over the two mounting studs located at 

top of door.
Use hex head screw driver or Allen wrench to tighten 

set screws from bottom to secure handle to door.

 

 

Mounting stud

Locate handle

Set screws

This Use & Care Guide provides general operating 

instructions for your model. Use the appliance only as 

instructed in this Use & Care Guide. Before starting the 

Choose a place that is near a grounded electrical 

• 

outlet. Do Not use an extension cord or an adapter 

plug.
For optimal performance, it is recommended 

• 

that you install the appliance where the ambient 

temperature is between 70 and 78 degrees 

Fahrenheit. 
Allow space around the unit for good air circulation.  

• 

Leave a 2 inch space on the back and sides of the    

wine cooler for adequate circulation. 
Be sure the appliance stays in the upright position  

• 

during transport.
Keep the appliance from any hazardous or 

• 

combustible agents.