Intel SR1680MV ユーザーズマニュアル

110

•

Are all cables correctly connected and secured?

•

Are the processors fully seated in their sockets

•

Are all standoffs in the proper location and not touching any components, causing a 

potential short?

•

Are all add-in PCI boards fully seated in their slots on the server board?

•

Are all jumper settings on the server board correct?

•

Are all jumper and switch settings on add-in boards and peripheral devices correct? 

To check these settings, refer to the manufacturer's documentation that comes with 

them. If applicable, ensure that there are no conflicts-for example, two add-in boards 

sharing the same interrupt.

•

Are all peripheral devices installed correctly?

•

If the system has a hard disk drive, is it properly formatted or configured?

•

Are all device drivers properly installed?

•

Are the configuration settings made in Setup correct?

•

Is the operating system properly loaded? See the operating system documentation.

•

Did you press the system power on/off switch on the front panel to turn the server on 

(power on light should be lit)?

•

Is the system power cord properly connected to the system and plugged into a 

NEMA 5 15R outlet for 100-120V or a NEMA 6-15R outlet for 200-240V?

•

Are all integrated components from the tested components lists? Check the tested 

memory, and chassis lists, as well as the supported hardware and operating system 

list. See 

 for links to the tested component 

lists.

Hardware Diagnostic Testing

This section provides a more detailed approach to identifying a hardware problem and 

locating its source.

1. Turn off the system and all external peripheral devices. Disconnect each device 

from the system, except for the keyboard and the video monitor.

2. Make sure the system power cord is plugged into a properly grounded AC outlet.
3. Make sure your video display monitor and keyboard are correctly connected to the 

system. Turn on the video monitor. Set its brightness and contrast controls to at 

least two thirds of their maximum ranges (see the documentation supplied with 

your video display monitor).