Motorola T1/E1 ユーザーズマニュアル
Canopy T1/E1 Multiplexer
September 2004
T1/E1 Multiplexer FPGA Version 3.4
Page 32 of 73
Figure 13: Rear panel Option 2: −48 v DC polarity
3. Connect the power cables to an external
−48 v DC supply.
end of procedure
2.3 INITIAL CONFIGURATION PROCEDURES
2.3.1 Installing Software from the CD‐ROM
Procedure 5: Installing Software from the CD-ROM
Follow these steps to install the software that is provided by Motorola Canopy on the CD-
ROM onto your PC.
ROM onto your PC.
1. Load software onto your PC.
The T1/E1 Multiplexer EMS Graphical User Interface is provided by Canopy on a
CD-ROM that is shipped with the unit.
CD-ROM that is shipped with the unit.
2. Install the software from the CD-ROM by double-clicking the setup application or
3. Issue
the
Start->Run->d:/setup sequence
where d: is the drive letter of your CD-ROM. If you are using a different drive
letter, simply substitute the appropriate drive letter.
letter, simply substitute the appropriate drive letter.
end of procedure
Issue 3