Motorola T1/E1 ユーザーズマニュアル

Canopy  T1/E1 Multiplexer 

 

 

 

 

 

 

September 2004 

 

 

 

 

 

 

     

      T1/E1 Multiplexer FPGA Version 3.4 

 
 

 

Page 34 of 73 

 

The Command Line Interface (CLI) is accessed using a PC with that includes a terminal 
emulation package such as HyperTerminal

®

. 

NOTE: The device is only accessible through the serial port. 

Before you use the CLI to configure the Canopy T1/E1 Multiplexer, you must configure 
the PC serial port.  

Use this procedure to access the CLI using a terminal emulation program such as 
HyperTerminal.

®

1.  Connect the serial cable from the DB9 serial port on a PC to the Serial port on 

the Canopy T1/E1 Multiplexer.  The DB9 connector on Canopy T1/E1 Multiplexer 
is female; the cable from the PC is male.  A straight-through cable is required. 

2.  Start HyperTerminal or another terminal emulation program. 

3.  Set the terminal emulation program to emulate a VT100 terminal with the 

following settings: 

 

Bits per second 

19200 

Data bits 

        8 

Parity none 

Stop bits 

        1 

Flow control 

none 

 

4. Press 

Enter. 

 

The Canopy T1/E1 Multiplexer Login menu is displayed. 
RESULT: The signal port is configured. 

 

To use the CLI, select Command Line Interface terminal from the File drop-down menu 
(illustrated in 

). The Command Line Interface window opens, as 

shown in 

 

Issue 3