Motorola T1/E1 ユーザーズマニュアル
Canopy T1/E1 Multiplexer
September 2004
T1/E1 Multiplexer FPGA Version 3.4
Page 37 of 73
10. At the username prompt, enter admin.
11. At the password prompt, enter your new password.
end of procedure
2.4.3 Select Line Type T1 or E1
Procedure 8: Selecting line type T1 or E1 using the CLI
Follow this procedure to select the appropriate line type using the CLI manager.
Action Steps
Log in
Press Enter.
At the username prompt, enter admin.
At the password prompt, enter password.
Get line type
Enter get line type.
RESULT: The system returns the line type for all four
ports, as in the following example:
RESULT: The system returns the line type for all four
ports, as in the following example:
Line type [T1/E1]
Set line type
Enter set line type [T1/E1]
where
T1
T1
sets the line type to T1 for all 4 ports.
E1
sets the line type to E1 for all 4 ports.
RESULT: The system acknowledges the new setting for
line type for all four ports, as in the following example:
Line type [T1/E1]
line type for all four ports, as in the following example:
Line type [T1/E1]
Reset system
Enter reset.
RESULT: The system responds Resetting, then
immediately resets both Ethernet Interfaces and all 4
T1/E1 interfaces without asking for a confirmation.
RESULT: The system responds Resetting, then
immediately resets both Ethernet Interfaces and all 4
T1/E1 interfaces without asking for a confirmation.
CAUTION!
The previously configured line type
remains in effect until the system is
reset. Therefore, this step should
always be followed by a reset.
remains in effect until the system is
reset. Therefore, this step should
always be followed by a reset.
end of procedure
Issue 3