Motorola T1/E1 ユーザーズマニュアル

Canopy  T1/E1 Multiplexer 

 

 

 

 

 

 

September 2004 

 

 

 

 

 

 

     

      T1/E1 Multiplexer FPGA Version 3.4 

 
 

 

Page 36 of 73 

 

NOTE: 
The default administrator account username is admin.  

The default administrator account password is 123.  
You cannot change the username. However, you can change the 
password at any time. If you forget your password, reset the system 
back to the default account and password by logging in, using the safety 
account. 
 

The safety account username is safety. 

The safety account password is SAFE_qwe. 
 

When you log in using this account, the password for the administrator 
account is reset to 123.The system will then log you out, at which point 
you may log in using the default administrator account username and 
password. 

To gain access to the CLI, log into the system as described under Configuration 
Procedures Using the EMS. 

Use this procedure to use the CLI manager to change the Administrator account 
password.  

1. Press 

Enter. 

2. At 

the 

username

 prompt, enter admin. 

3.  At the password prompt, enter 123. 

4.  Enter change password. 

5.  At the prompt Enter your old password: Password:, enter your old 

password.  

6.  At the prompt Enter your new password: Password:, enter your new 

password.  

7.  At the prompt Enter your new password: Password:, re-enter your new 

password. 
RESULT: The system responds: Password has been changed. 

8.  To log off, enter lo. 

9. Press 

Enter. 

Issue 3