3com TR ユーザーズマニュアル
5
C
ONFIGURING
WITH
THE
LCD C
ONSOLE
This chapter describes the Switch 2000 TR LCD Con-
sole management facilities and provides procedures
for configuring and managing the device. This con-
sole is accessed from the front panel and provides
access to most configuration, management, and
monitoring facilities. This chapter assumes you have
prepared the Switch 2000 TR for management.
sole management facilities and provides procedures
for configuring and managing the device. This con-
sole is accessed from the front panel and provides
access to most configuration, management, and
monitoring facilities. This chapter assumes you have
prepared the Switch 2000 TR for management.
■
■
■
■
For more information on the LCD Console, refer to
“LCD Status in Chapter 6 and “Setting Up the LCD
Console in Chapter 3.
“LCD Status in Chapter 6 and “Setting Up the LCD
Console in Chapter 3.
Unit Configuration
The most important task of setting up the Switch
2000 TR is assigning a Unit ID number to the indi-
vidual units. When installed as members of a
stack, up to 6 Switch 2000 TRs form the equiva-
lent of a switching chassis, managed using the
same IP address. All traffic, management, moni-
toring, and configuration tasks and inquiries
operate through the high-speed cascade located
at the rear of each unit. The Unit ID number rep-
resents the position of the Switch 2000 TR in a
stack. Each Switch 2000 TR must be assigned a
unique Unit ID number. The LCD Console pro-
vides the best method for this task.
2000 TR is assigning a Unit ID number to the indi-
vidual units. When installed as members of a
stack, up to 6 Switch 2000 TRs form the equiva-
lent of a switching chassis, managed using the
same IP address. All traffic, management, moni-
toring, and configuration tasks and inquiries
operate through the high-speed cascade located
at the rear of each unit. The Unit ID number rep-
resents the position of the Switch 2000 TR in a
stack. Each Switch 2000 TR must be assigned a
unique Unit ID number. The LCD Console pro-
vides the best method for this task.
To set the Unit ID number, proceed as follows from
the Switch 2000 TR>Unit banner:
the Switch 2000 TR>Unit banner:
1
Press [Enter] twice.
2
Using the [Up or Down Arrows], set the Unit ID to #1.
NOTE:
If the unit you are configuring is to be the
head unit, it must be the lowest number in the stack.
3
Press [Enter] to accept (save) the Unit ID #.
4
Press the [Left Arrow] to return to the Switch 2000 TR
>Unit screen and complete the remaining LCD config-
uration tasks as described in this section or use the
VT100 console as described in Chapter 4.
>Unit screen and complete the remaining LCD config-
uration tasks as described in this section or use the
VT100 console as described in Chapter 4.